FAQs
More FAQs- Can I strip floors with urethane finish?
- Will there be an odour after you clean the carpets?
- When will I be able to walk on the carpet after it has been cleaned?
Urethane is strippable, if necessary. However, when the product reaches the end of its life cycle, it can be abraded and recoated without stripping. ServiceMaster Of Calgary has products and procedures designed specifically for this purpose.
Depending on the type of carpet we’re cleaning, you may notice a faint scent. This is especially prevalent when cleaning wool carpets. The amount of time it takes for the odour to dissipate is usually within an hour but varies based on air circulation, heat and humidity. A big difference in the way ServiceMaster Of Calgary cleans carpet compared to many of our competitors is that we do not put soap in our rinse water. We pre-spray the carpets, remove the spots, then use clean water extraction to ensure that we do not leave any soapy residue behind. This allows for fresh, clean carpets
This depends on whether a low-moisture encapsulation or a deep clean of your carpet has been applied. However, a general rule of thumb is to allow a drying time of six to eight hours before you can walk on your carpet.